1. Brief introduciton 
Aluminum rod continuous casting and rolling line can produce three kinds of conductive aluminum rods of *5, *2, 9.5mm. *5mm aluminum rod is produced by *1 rolling stands; *2mm aluminum rod is produced by *3 rolling stands and 9.5mm aluminum rod is produced by *5 rolling stands. 

2. Process Flow 
2.1. Aluminum ingot and scrap aluminum wire - aluminum melting furnace -Four-wheel horizontal continuous casting machine -oil hydraulic shearer-continuous rolling mill -oil tank and leading pipe -coiler with dual basket 

2.2. Melt aluminum or prepared melt aluminum is injected to four-wheel continuous casting machine through launder and is cast to aluminum bar of 2, **0 mm² . Scrap aluminum bar is cut by oil hydraulic shearer and then acceptable aluminum bars are sent to continuous rolling mill. Conductive aluminum rods are sent to coiler with dual basket via oil tank and leading pipe and coiler. 

3. Main Technical Parameters 
3.1. Diameter (of finished products of conductive Aluminum rod): φ 9.5 φ *2 and φ *5mm (as customer requested) 
3.2. Capacity: 2.**4.2 t/h 
3.3. Coil's weight: ~2t 
3.4. Overall weight of main equipment: ~ *5t 
3.5. Overall power of main equipment: ~**0kW (excluding furnace) 
3.6. Finished rolling speed: ≤ 6.2m/s 
3.7. Overall dimension: Approx. *2.1× 7.2× 4.2m (L × W × H) 

4. Supply of scope 
4.1 Four-wheel Continuous Casting Machine 
4.2 Single-Track Oil Hydraulic Shearer 
4.3 Continuous Rolling Mill 
4.4 Emulsion Lubrication System for Rolling Mill 
4.5 Lubrication System for Gearbox 
4.6 Oil Tank and Leading Pipe 
4.7 Coiler and Coiler with Dual Basket Trolley 
4.8 Electrical Control Device